How To Cut Access Hole In Drywall

The family handyman editor mark petersen will show you how to layout the hole and cut it for a professional fit.

How to cut access hole in drywall. Squirt a small bead of construction adhesive along the rear perimeter of the flange and press the housing into place. At the chosen spot level the housing on the wall and trace its outline with a pencil. Cut a small hole in the drywall check your measurements by cutting a small hole into the drywall right at the.

How to cut an access panel in drywall 1. Use a pencil to mark the. Identify the spot where you want to make a hole for an inspection or to access something behind the drywall.

Cut a small pilot hole about 2 inches wide using a drywall saw. Press an electric stud finder against the wall to locate the studs behind the drywall. If you have a small drywall job to do there is no need to buy or rent a rotary tool to cut around electrical boxes.

Trace the access panel. First you need to measure the distance from the edges where you will hang the drywall board to the center of the hole. Connect the hole saw drill bit to a drill machinery with torque control.

Cutting circular holes in drywall. Surface mounting an access panel is quick and easy. Mark the outline of the section you want to cut out with a pencil.

Place the frame of. Locate the fixture whatever needs accessing make sure you know exactly where it is. In this part 2 video i m going to show you how to cut out and install drywall on a water damaged drywall ceiling.